Physics Question, Mechanical Engineering

Hello to whom it may concern. I am currently having much trouble with a physics problem. I have an inverted L beam lying on a table. At the end of the flat piece laying on the table is a rectangular piece about 1/5 the length of that side. That little piece is then connected into a space in the table on an able and once all the way through becomes parallel with the table. What would the stress be on this point if there was a load on the base hanging from the table.
Posted Date: 2/2/2013 8:22:33 PM | Location : Canada







Related Discussions:- Physics Question, Assignment Help, Ask Question on Physics Question, Get Answer, Expert's Help, Physics Question Discussions

Write discussion on Physics Question
Your posts are moderated
Related Questions
A 68.0 kg crate rests on a level floor at a shipping dock. The coefficients of static and kinetic friction are 0.780 and 0.430, respectively. (a) What horizontal pushing force i

Q. What are the Specific Issues with plant Layout? There are a large number of regulations and related material that impact the operating plant. API (American Petroleum Institu

Fixed type In this set up, the welding head is kept fixed and the movement required during welding is provided through in the jobs to be welded. A typical application of this arr

Methods of analysis of trusses: What are the methods of analysis of trusses? What is found when the analysis of a system is done? Sol.:  The forces in the members of

(a) What are the causes of high fuel consumption? (b) How can the problem of "motorcycle pulls to one side" be corrected? (c) How can engine overheating problem be solved?

Drive an mathmatical expression for condition of maximum discharge through the chimney. Dry saturated steam is supplied from a boiler to a steam engine at a pressure of 15 bar.

A jet of water moving at 8 m/sec. impinges on a concave-shaped vane to deflect the jet through 120 o when stationary. If the vane is moving at 5 m/sec., calculate the angle of jet

Prove the parallelogram law of forces: Assume that the two forces P and Q act at a point ' O ' as shown in figure given below. The force P can be represented in magnitud

Motion on the inclined plane when the surface is smooth: Sol:  WHEN THE SURFACE SMOOTH   The Figure given shows a body having weight W, sliding down on a smooth in

The Center Mark Command We can use  Center Mark command to annotate a circle or an arc with a cross at the center.Illustration above shows a center mark added to a circle quick