Periodic motion-frequency-time period-free vibration, Mechanical Engineering

Periodic Motion: This is the motion that repeats after a regular interval of time.

This is the number of cycles finished in a unit time.

Time Period:
This is the time taken to complete one cycle.

Amplitude: This is maximum displacement of a vibrating system from the position of mean equilibrium position.

Free Vibration:
This is the vibration of the system that occurs without any external force after the disturbance.

Posted Date: 12/12/2012 6:12:11 AM | Location : United States

Related Discussions:- Periodic motion-frequency-time period-free vibration, Assignment Help, Ask Question on Periodic motion-frequency-time period-free vibration, Get Answer, Expert's Help, Periodic motion-frequency-time period-free vibration Discussions

Write discussion on Periodic motion-frequency-time period-free vibration
Your posts are moderated
Related Questions
Calculate total deflection -two close-coiled helical springs: Two close-coiled helical springs are compressed among two parallel plates by a load of 1000 N. The springs contai

Q. Show Corrosion Loss? Additional metal thickness must be added, to compensate for anticipated loss due to metal reacting with the environments to which it is subjected, inclu

Define strain: Sol. : STRAIN(e) : When the body is subjected to some external force, there is some change in dimension of body. The ratio between change in the dimension of b

Calculation for Stress-strain carves:   After reaching point D, if bar is strained further, a local reduction in cross section occurs in gauge length (that is, formati

Q. Stress analysis requirements? All other lines requiring review by the stress group are to be checked for adequate support, stability, excessive movement, etc. Where hand ca

Q. Stress analysis reporting? • Stress sketch with all node points, dimensions, pipe schedule, weights of non-standard components, e.g., control valves and actuators, insulatio

A shaft is hinghed by two bearings placed 1.0 m apart. A 600mm diameter pulley is mounted at a distance of 300 mm to the right of left hand bearing and this operates a pulley direc

what are the necessery calculation required to design a gripper?

calculate the vertical reaction at A in Newtons