Parallelogram law of forces - mechanics, Mechanical Engineering

Parallelogram law of forces:

The law of parallelogram is used to determine the resultant of two forces acting at the point of a rigid body in plane and is inclined to each other at the angle of a.

It state that if the two forces acting simultaneously on a particle, be represented in direction and magnitude by the two adjacent sides of a parallelogram then their resultant can be represented in magnitude and direction by diagonal of parallelogram that passes through their point of intersection."

 

 

Posted Date: 10/16/2012 1:22:11 AM | Location : United States







Related Discussions:- Parallelogram law of forces - mechanics, Assignment Help, Ask Question on Parallelogram law of forces - mechanics, Get Answer, Expert's Help, Parallelogram law of forces - mechanics Discussions

Write discussion on Parallelogram law of forces - mechanics
Your posts are moderated
Related Questions
Compaction This is carried out in several manners that might occupy the addition of a binder or lubricant and application of pressure. Sintering is densification of assembled

Q. Overview of Project Phases? Conceptual Engineering Phase The purpose of this phase of work is to develop the Client's proposal to a level of detail adequate to determin

Define Flavorings in IGES Flavorings : IGES contained several ways to capture the same information, which made proper interpretation largely dependent on the particular  "fla

when does the cyclic service apply for pressure vessels in batch plant (operation)

Q. Why we use cold working? Cold working takes place below the recrystallization temperature, and therefore is fundamentally different at the atomic level with effects up to th

List and explain the five stages of change. What stage are you at in regards to your own exercise program and explain why? (50-100 words) Refer to page 4 of The Essential Guide to

Discuss relative demerits and merits of belt, rope and chain drive for transmission of power and find the condition for transmitting the maximum power in a flat belt drive.

Dismantle crank case and explode main shaft , counter shaft, gear shifter drum and kick spindle assembly and check sequence of parts fitment while dismantling: Check all gear teeth

Calculate force required for equilibrium: A member ABCD is subjected to the point loads P 1 , P 2 , P 3   an d P 4   as shown in the figure given below

Q. Method of construction - Plant layout? Plant layout is influenced by the intended method of construction, whether the plant is being constructed on-site, or whether modules