All Pages

Assignment Help:

Figure below shows a jib crane. In this type of crane the hook can move in a circular path. A jib crane is preferred where lifting of the jobs is required in few location only or where bridge crane cannot be erected. In a jib crane hoist unit may be mounted on an section jib which is in turn supported on a column.

Calculate size of blank required for drawing, Calculate Size of Blank Requi...

Calculate Size of Blank Required for Drawing A flanged cup shown in Figure is to be produced by deep drawing. Calculate the size of the blank required for drawing.

Position of centre of gravity of the frustrum of a cone, Position of centre...

Position of centre of gravity of the frustrum of a cone: situate the position of C. G. of the frustrum of a cone with height H = 12 cm and with  diameter 8 cm and 12 cm at top

First law of thermodynamics, common formula for first law of thermodynamics...

common formula for first law of thermodynamics #Minimum 100 words accepted#

Shielding gas-argon - hydrogen mixtures, Argon - Hydrogen Mixtures A...

Argon - Hydrogen Mixtures Argon - hydrogen mixtures are employed in special cases, such as mechanised welding of light gauge stainless steel tubing, in which the hydrogen do

Find out the wave retarders in tandem, Wave Retarders in Tandem Write th...

Wave Retarders in Tandem Write the Jones matrices for the following retarders: (a) A π/2 wave retarder with the fast axis along the x direction. (b) A π wave retarder with

Find the stresses by finite method, The stepped bar in Fig Q6 is stretched ...

The stepped bar in Fig Q6 is stretched along the vertical axis and the maximum upward displacement is found to be 0.008 m. The bar has cross-sectional areas of A 1 and A 2 ov

Thermodynamics, what is gauge pressure?

what is gauge pressure?

What are the capabilities of step, What are the capabilities of STEP In...

What are the capabilities of STEP Industry-Developed STEP Capabilities AP-203, Configuration Control for 3D Design of Mechanical Parts and Assemblies, provides a very robust

Calculate the flow rate and pressure drop , (a) Oil, with density ρ= 900 kg...

(a) Oil, with density ρ= 900 kg/m 3 , and kinematic viscosity υ=0.00001m 2 /s, flows at the rate of 0.2m 3 /s through 500m of a cast iron pipe of diameter d=200mm. Using this infor

Calculate the displacement of a particle, Calculate the displacement of a p...

Calculate the displacement of a particle: The displacement of a particle is given by the equation, x = 10 t 3  - 7 t 2   + 6 t + 2       I.            Calculate its d  