Over-hanging and cantilever beam - support reaction , Mechanical Engineering

Over-Hanging and Cantilever Beam:

Over-Hanging Beam: The beams on which one end or both ends are overhang are called as overhanging beam.

1560_Over-Hanging and Cantilever Beam.png


3. Cantilever Beam: If a beam is fixed at one end and is free at the other end, it is called cantilever beam, In the cantilever beam at the fixed point(end), there are three support reaction horizontal (RH), vertical reaction(RV), and moment(M)

 

2050_Over-Hanging and Cantilever Beam1.png

 

Posted Date: 10/17/2012 3:54:35 AM | Location : United States







Related Discussions:- Over-hanging and cantilever beam - support reaction , Assignment Help, Ask Question on Over-hanging and cantilever beam - support reaction , Get Answer, Expert's Help, Over-hanging and cantilever beam - support reaction Discussions

Write discussion on Over-hanging and cantilever beam - support reaction
Your posts are moderated
Related Questions
Evaluate stress in fibre: Example, the matrix material can be stressed to its full strength of 80 MPa, calculate the allowable % of broken fibres. What will be the stress in f

Q. Explain about Vertical Vessels? Vertical vessels shall normally be designed as self-supporting units, and shall resist overturn based upon wind or earthquake considerations.

Aggregate Production Planning: This unit provides the definition and physical significance of aggregate production planning. Further, this is illustrated that how the internal

Grease Gun: A grease gun is shown in Figure. This is used to supply semi-solid lubricant (grease) for chassis lubrication. Figure : Grease Gun

Loose piece pattern This type of pattern is also used when the contour of the part is such that withdrawing the pattern from the mould is not possible. Hence during moulding th

Metals and Melting Practices - Ladle, Limestone,Ore,Sinter Ladle : A big bucket utilized as a carrier for molten metal. Limestone : A Blast Furnace raw material that elimi

The following guidelines are intended to assist the HVAC lead, designer or auditor in preparing an assessment of the quality of the HVAC engineering work for a specific project. T

The square cross sections A and B are shown in Fig Q1, the dimensions b = 80 mm, thickness t = 10 mm. A shear force V is applied at the cross section, calculate the maximum she

Q. Seismic Loads For Structure-Mounted Equipment? For equipment mounted in a structure above grade, the governing equation for seismic force is: F p = A v C c Pa c W c , wh

how to calculate machining time for milling operation