NIRAN, Other Engineering

Why spiral model is called meta model?
Posted Date: 6/7/2014 8:48:59 PM | Location : USA







Related Discussions:- NIRAN, Assignment Help, Ask Question on NIRAN, Get Answer, Expert's Help, NIRAN Discussions

Write discussion on NIRAN
Your posts are moderated
Related Questions
Procedures for starting and ground running: Before starting and ground running any gas turbine powered aircraft, several considerations must be taken into account. The first an

Measurement of thermocouple voltage The voltage is typically only a few millivolts and should be measured using a high impedance system. If an amplifier is used, must also have

Interest Rate Calculations In considering the time value of money, it is convenient to represent mathematically the relationship between the current or present value of a sing

2. A contractor has both a 3-cy and a 5-cy shovel in the equipment fleet. Select the minimum size shovel that will excavate 400,000bcy of common earth in a minimum of 130 working d

Provided a 1D array of integers, find all combinations of 3 values from this set such that: a+b+c=0 For example, if one were provided with the set [3 1 3 -4 -6], the resulting answ

Need to understand the method for calculating the maximum deflection and maximum stresses on a rigidly supported circular plate. The plate has a 500 mm radius and is 12mm thick.

PERMIT TO FLY A Permit to Fly may be issued to an aircraft that does not, for a variety of reasons, fully comply for a Certificate of Airworthiness. These reasons might be b

Servo accelerometer Electro-mechanical servo (force balance) accelerometer uses an electromagnet to provide restoring force. The position of the seismic mass is measured by a p

Lift and drag are merely the resolved components in specific directions of a resultant aerodynamic force caused by the relative velocity V of the vehicle through the air. If al

Difference between   Blow hole and pin hole porosity          Blow hole : They appear as cavities in a casting. When they are visible on the upper surface of the castings, th