Mvi move immediate instruction , Electrical Engineering

MVI Move Immediate  Instruction

This form  of the instruction is used to copy 8bit  data ( specified  in the  instruction )  directly  into the  register or memory  pointed by register pair HL. The general  instruction is.

MVI Destination 8 bit data

There  are two  possible  formats  to copy  8 bit  data into  register  and memory .

Posted Date: 4/4/2013 5:29:02 AM | Location : United States







Related Discussions:- Mvi move immediate instruction , Assignment Help, Ask Question on Mvi move immediate instruction , Get Answer, Expert's Help, Mvi move immediate instruction Discussions

Write discussion on Mvi move immediate instruction
Your posts are moderated
Related Questions
Explain the hysteresis loop of a magnetic material. Hystereses loop-Below the Curie temperature all-ferromagnetic materials show the identified hysteresis in the B (i.e. flux

Q. Explain Current-to-Voltage Amplifier? The basic circuit is shown in Figure, which is similar to that of an inverting amplifier. The - input is connected directly to a curren

Defective Metering and Meter Reading Errors Defective Metering Tampered, slow running, stalled, damaged meters are a cause of huge losses to the utility. The electromecha

Multiple Tariff Meters or TOU Meters Time of use metering facilitates load control and planning on the part of utilities. This is efficiently achieved using a concept known as

I want simulink model for carrier based pwm method

Collector-to-base bias: Figure: Collector-to-base bias This configuration uses negative feedback to avoid thermal runaway and stabilize the operating point. In th

Tariff Filing Asset-wise details for each business of licensee; Audited accounts and financial statements, including cash flows for the preceding years and monthly bal

Q. Draw a centralized SPC organization. Ans: A dual processor architecture can be configured to operate in one of three modes: (i)  Standby mode (ii)  Synchronous dupl

Let both coherent ASK and coherent PSK systems transmit the same average energy per bit interval and operate on the same channel such that E b /N 0 = 18. Determine the bit-error p

What is an interrupt? An interrupt is either a software-generated CALL or hardware-generated CALL.