Microwave, Physics

Write an assembly program to make a microwave.

Need:

1.    The microwave has a clock (hh:mm:ss am/pm) and the user should be able to alter the clock at any time.

2.    For cooking the user should inital enter the time. The user can enter the time by:

a)    Pressing 1, 2, ..., 6 and that will set the time to 1, 2, ..., 6 minutes (Express)

  • If the door is closed the microwave should begin immediately.
  • If the door is not closed after closing the door the user should click start in order for the microwave to begin

b)    Clicking the enter time button and then the user can enter the desired time in minutes and seconds (the user can enter up-to 20 minutes and 0 seconds). The user should then click the start button for the microwave to begin if the door was closed

  • If the user entered 5 that means the user entered 5 seconds
  • If the user entered 5-7 that means the user entered 57 seconds
  • If the user entered 5-7-8 that means the user entered 5 minutes and 78 seconds

3.    The user can select the power level (Hi-Medium-Low)

  • The microwave should begin with a default power level

4.    Cooking is simulated by the stepper motor

  • The speed is determined by the power level selected
  • The direction should change after:

 

 

Posted Date: 3/21/2013 3:19:50 AM | Location : United States







Related Discussions:- Microwave, Assignment Help, Ask Question on Microwave, Get Answer, Expert's Help, Microwave Discussions

Write discussion on Microwave
Your posts are moderated
Related Questions
What are synthetic rubbers? Give the preparation and structure of any two synthetic rubbers.

how many seconds dose it take an elevator to travel 373m if it accelerates at 4.80 m/s^2 and has a velocity of 17.8m/s how much time does it take an elevator to travel 373 meters

A boy throws a ball vertically upward with a velocity of 6 meters per second. How long does it take the ball to return to the boy's hand? Ans: A boy throws a ball vertically

The cantilevered beam below is supported at O.  F1 and F2 in kN are given in P21 and P22 respectively and act on the beam as shown.  Determine the magnitude and direction of a sing

The distance at any time because of any value of pulse meeting concurrently at a position in a medium is the vector addition of the individual distances due every one of the ray at

A lever of the second class Use a uniform wooden bar about 1 m long, 4 cm wide and 5 mm thick. Drill a hole near single end, in the centre of the width dimension. Also drill a

Average and Instantaneous Acceleration: Average acceleration is explained as the change in velocity   over a given time interval. As, The instantaneous acceleration of g

Inertia on a bicycle Get your bicycle going and then apply the brakes rapidly. View the tendency of your body to stay in motion and pitch you over the handlebars. This is the r

A circuit contains of a 10 volt battery connected in series with a 4 ohm resistor and a 6 ohm resistor. A person computes the current through the 4 ohm resistor using Ohm's Law by

A tank is filled up to a height 2H by a liquid and is placed on a platform of height H from the ground .the distance x from the ground where a small hole is punched to get maximum