Metals and Melting practices - alloy,blowing,carbon monoxide, Mechanical Engineering

Metals and Melting Practices - Alloy,Blowing,Carbon Monoxide

Alloy: Usually a mixture of metals but steel is an alloy that has some non-metals, especially carbon.

Blowing: An operation in which a gas, frequently oxygen, is blown into the furnace.

Carbon Monoxide: A toxic flammable gas, formula CO. The gaseous reducing agent that decrease iron ore in the Blast Furnace.

 

Posted Date: 12/18/2012 7:45:53 AM | Location : United States







Related Discussions:- Metals and Melting practices - alloy,blowing,carbon monoxide, Assignment Help, Ask Question on Metals and Melting practices - alloy,blowing,carbon monoxide, Get Answer, Expert's Help, Metals and Melting practices - alloy,blowing,carbon monoxide Discussions

Write discussion on Metals and Melting practices - alloy,blowing,carbon monoxide
Your posts are moderated
Related Questions
Drynes s Fraction of Steam: Dryness fraction of steam is factor which used to specify the quality of steam. It can be defined as the ratio of weight of dry steam W d s pr

Scrapper: Scrappers are used to scrap gasket or other such materials from flat or irregular surface. Scrappers of several sizes are shown in Figure. Figure : Scrapper

Evaluate resultant of the system: Q: Figure given below shows two vertical forces and couple of moment 2000 Nm acts on horizontal rod, which is fixed at end A .  Determin

How can i change the normal function block parameter[1 1]=>(s+1) to (s-1)?

Estimate the Weight of the Casting A Yoke casting shown in Figure is to be produced by sand casting process. Estimate the weight of the casting if the density of the material


What is fluid mechanics? what are cohesive and adhesive forces?

Important section of fly-overs and underpasses: Culverts : A structure having a waterway upto 5 m. Minor Bridge : A structure having a waterway of 6-30 m. Medium Si

Q. Mechanical design of the blowdown systems? Mechanical design of the blowdown systems shall be sized for a continuous blowdown of a minimum of 1.0% of MCR. Fabricator may re

Q. What is Transfer molding? Transfer molding was developed largely to avoid the disadvantages found which compression molding. • Transfer molding can make intricate or quit