mechanical properties of materials, Mechanical Engineering

A tensile test on a specimen having an initial diameter of 13.11 mm and an initial gauge length of 200.0 mm, gave the following data:

Related Discussions:- mechanical properties of materials

Determine lift coefficient, A thin spanwise symmetrical wing has an aspect ...

A thin spanwise symmetrical wing has an aspect ratio of 10 and a straight edges with taper ratio (tip chord / root chord) of 0.8 and root chord of 1 m. This wing does not have geo

What is the difference between mis and erp, MIS MIS:- Management Infor...

MIS MIS:- Management Information System Produces reports on user demand MIS is use for the Decision making reports It Collect data form of all department then produce

Obtain the closed loop transfer function, Question: The block diagram o...

Question: The block diagram of a dc servo motor feed drive is shown Obtain the closed loop transfer function relating the output to the disturbance T L while V

Material engineering, State the four classes of engineering materials 3 (b)...

State the four classes of engineering materials 3 (b) Identify the class which each of the following materials belong to. Present your answer in table form Silicone, concrete, chro

#flow rate in turbochargers, What is the amount of air is supplied to engin...

What is the amount of air is supplied to engine via turbochargers and how their sizes vary from engine to engine ?

Determine the maximum uniformly distributed load, Determine the maximum uni...

Determine the maximum uniformly distributed load: A timber beam 150 mm wide & 300 mm deep is supported simply over a span of 4 m. determine the maximum uniformly distribute

Lest count, what is the least count of following instrument? vernier calipe...

what is the least count of following instrument? vernier caliper micrometer bevel protractor dial

Measurement of hardenability, Measurement of Hardenability: Two testi...

Measurement of Hardenability: Two testing techniques have been enhancement to measure the harden-ability of steels. The first, termed as cylinder series test, offers a single

Determine the stress in steel rod, A steel rod of 3 cm diameters and 5 m lo...

A steel rod of 3 cm diameters and 5 m long is connected to two grips and the rod is maintained pull exerted when the temperature falls to 30 o C if (a) The ends do not yield, an

Concept of absolute thermodynamic temperature scale, (a) Write short note o...

(a) Write short note on steady flow energy equation and its applications. (b) A heat engine operating between two reservoirs at 1000k and 300k is used to drive a heat pump which

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages