Matlab Applied Optimization Problem, Mechanical Engineering

A fenced enclosure consists of a rectangle of length L and width 2R, and a semicircle of radius R, as shown in Figure P20. The enclosure is to be built to have an area A of 1600 ft2. The cost of the fence is $40/ft for the curved portion and $30/ft for the straight sides. Use the min function to determine with a resolution of 0.01 ft the values of R and L required to minimize the total cost of the fence. Also compute the minimum cost.
Posted Date: 9/15/2012 11:26:48 PM | Location : United States







Related Discussions:- Matlab Applied Optimization Problem, Assignment Help, Ask Question on Matlab Applied Optimization Problem, Get Answer, Expert's Help, Matlab Applied Optimization Problem Discussions

Write discussion on Matlab Applied Optimization Problem
Your posts are moderated
Related Questions
use, application benifits and working of willson hartnell governor

what is the difference between point function and path function?

Q. Show Prevailing wind conditions for plant layout? Prevailing wind conditions influence the design considerations for the location of the flare or vent stack. It is vital tha

Difference between SI and CI engines SI engine stands for spark ignition engine while CI engine stands for compression ignition engine. SI engine works on the principle of w

Determine the percentage savings in the material: A hollow shaft containing an inside diameter 0.5 times the outer diameter is to replace the solid shaft of the similar materi

If Low Resistance or Very High Current in Primary Coil Circuit Causes of Problem Remedy Primary ignition coil short circuited


Explain Internal Broaching - Types of Broaching Internal broaching operation is adopted for producing internal surface such as holes, keyways and teeth of an internal gear for

The following data were obtained from a test on a single cylinder, double acting steam engine fitted with a rope brake. Cylinder diameter 200mm Stroke 250mm Speed 5rev/min Effec

The Bronzes The coinage bronze employed for making coins in earlier days contains 95% copper, 4% Sn and 1 % Zn. The Zn acts as a deoxidizer. Such alloy is soft and ductile.