material and energy balances, Chemical Engineering

Wet air containing 4.0 mole% water vapor at 76°F and 14.8 psia is passed through a column of calcium chloride pellets. The pellets absorb 97% of the water and none of the other constituents of the air. The column packing was initially dry and had a mass of 3.40 kg. Following 5.0 hours of operation, the pellets are reweighed and found to have a mass of 3.52 kg. Calculate the molar flow rate (mol/h) of the feed gas and the mole fraction of water vapor in the product gas.
Posted Date: 7/27/2013 3:34:08 AM | Location : Malaysia







Related Discussions:- material and energy balances, Assignment Help, Ask Question on material and energy balances, Get Answer, Expert's Help, material and energy balances Discussions

Write discussion on material and energy balances
Your posts are moderated
Related Questions
CLASSIFICATION OF CHEMICALS IN THE STORE Your Counsellor will give you names of any five chemicals. You fill up the report in tabular form (Table) indicating the name of the ch

Requisites of refractory material or essential requirements of good refractory: a.      It should be able to withstand high temperature. The appropriate refractory is chose

Mixing Salt Solutions You mix 195.0 gallons of a mixture containing 12.00 wt% NaCl (sodium chloride) and 88.00 wt% water (solution density = 1.0837 g/cm 3 ) with a V 2 -gallon

how to write project report for chemical engineering

A single-effect evaporator is used to concentrate 60000 kg h -1 of a 40 wt % NaOH solution which is fed to the evaporator at 40°C. The concentrated liquid is a 55 wt % NaOH soluti

air flows through apipe at arte of 200L/S. The pipe of two sections of diameters 20cm and 10cm with asmoth reducing section the pressure are difference between the two pipe sectio

Which one of the following statements is correct? You may wish to examine a molecular model of this compound. 1. Carbon D is an asymmetric center and its configuration is R 2

the inlet diameter of venturimeter 25mm and diameter of throat is 15mm.The coefficient of discharge for venturimeter is Cv=0.98.The height is found to be 5ml density of water is 10

what is break point on chlorination

It is desired to concentrate a NaOH solution from 12.5 % to 40% in a double effect evaporator. 50,000 lb/hr of feed solution enters the evaporator at 120 o F, and steam at 15 psig