Match plate patterns, Other Engineering

Match plate patterns are used where a rapid production of small and accurate castings is desired on a large scale. These patterns find a great favour in machine moulding. Their construction cost is quite high, but the similar is simply compensated by a high rate of production, higher dimensional correctness and minimum requirement for machining in the casting.

Posted Date: 8/3/2012 2:06:09 AM | Location : United States







Related Discussions:- Match plate patterns, Assignment Help, Ask Question on Match plate patterns, Get Answer, Expert's Help, Match plate patterns Discussions

Write discussion on Match plate patterns
Your posts are moderated
Related Questions
Investment allowance Until a few years ago, a company could charge an amount equal to 25 per cent of the original value of an asset as investment allowance in the period in which

Income statement: Sosa Corporation recently reported an EBITDA of $31.3 million and $9.7 million of net income. The company has $6.8 million interest expense, and the corporate tax


PITCH LOCK MECHANISM The pitch lock mechanism is necessary to cater for the two fine pitch position of 'flight fine pitch' and 'ground fine pitch'. It acts as a safety device

INSTALLATION OF PROPELLER The method of installation will depend on the type of propeller, and all instructions detailed in the appropriate AMM should be carefully followed; th

2-17 Given a wind speed of 5.0 m/s at 2 m above the ground and a roughness length of 0.8 cm, compute (a) the friction velocity, in centimeters per second, and (b) the wind speed, i

External cooling Cooling of the external skin of an aero-engine is achieved by suitable design of the aircraft airframe; the layout will depend upon where the engine is fitted

Notation for Body Axes The standard notation for the body axis sytem for aircraft dynamics. This sectionexplains the signi?cance of the term body axis and develops the non-line

Changes in temperature and pressure: The changes in temperature and pressure of the gases through a gas turbine engine are illustrated in Figure 1.5 The efficiency with which t

Difference Between Fin and Swell          Swell : The unintentional bulges found on the casting surfaces are known as swells. Such enlargements on the casting surface are cau