manufacturing, Mechanical Engineering

machine tool derives
Posted Date: 3/1/2013 2:23:03 AM | Location : USA







Related Discussions:- manufacturing, Assignment Help, Ask Question on manufacturing, Get Answer, Expert's Help, manufacturing Discussions

Write discussion on manufacturing
Your posts are moderated
Related Questions
(a) Draw P-H and T-S diagrams for following cases : (3) (i) Cycle with superheated vapour before compression. (ii) Cycle with sub-cooling or under-cooling of refrigerant.

Brinel l Hardness Test: Insert the Ball of diameter D in ball holder of machine. Make specimen surface free from dust and dirt. Make contact between the surface and ball b

Martempering: The piece to be hardened is wholly austenitized and after that quenched in a lead of salt bath held at a temperature simply above at that martensite would begin

IMPO R T AN T TERMS: Fi r e Box: Place where fuel is burnt. Grat e : The fuel is burnt on this. Baffles : Plates are used for directing the flow of flue gass

What is wave? How many type of the waves?

Frictional force acting on the ladder: A uniform ladder having length 13m and weighing 250N is placed against smooth vertical wall with its lower end 5m from wall. The coeffi

Point of inflexion: Define the term point of contraflexure or point of inflexion. Also define point of zero shear force?  Sol.: The points (other than extreme ends of beam)

how bike''s hydraulic shock absorbers work?

Define strain: Sol. : STRAIN(e) : When the body is subjected to some external force, there is some change in dimension of body. The ratio between change in the dimension of b

Determine the maximum shear stress: A beam of triangular cross section of base width 120 mm & height 80 mm is subjected to a shear stress force of 3 kN. Determine the maximum