Maintenance of drainage and shoulders, Civil Engineering

Maintenance of Drainage:

Maintenance of drainage will ensure that the run-off is taken away from the runway efficiently. The side ditches and buried pipes should be cleaned regularly such that they are not clogged.

Maintenance of Markings

Repainting of markings which are worn out should be done periodically.

Maintenance of Shoulders

Shoulders should be graded periodically to ensure that they have the desired outward slope. Any shoulder drop-off at the runway/taxiway edges should be made good. All grass and shrubs should be cut and trimmed.

Posted Date: 1/23/2013 1:46:29 AM | Location : United States







Related Discussions:- Maintenance of drainage and shoulders, Assignment Help, Ask Question on Maintenance of drainage and shoulders, Get Answer, Expert's Help, Maintenance of drainage and shoulders Discussions

Write discussion on Maintenance of drainage and shoulders
Your posts are moderated
Related Questions
Define the Rectangular Weirs Sometimes referred to as "sharp crested weirs" if the top edge of the weir plate is narrow

Embankment Construction: Selection of Soil Soil is the material used for embankment construction, though other materials like rock and fly-ash are also used in specia

Three alternatives are being considered for improving a street intersection.The annual dollar savings on account of the improvement is shown below.  Assume that the intersection wi

Question What are the functions components of a typical expansion joint ? Answer In a characteristic expansion joint, it normally contains following mechanism-joint sealant, jo

A clay stratum is 4.5 m thick and rests on a rock surface. The coefficient of consolidation of a sample of this clay was found to be 4.5 × 10-8 m 2 /s in the laboratory. Verify pro

rebound hammer working mechanism with detailed specifications of the images

Allowable Strength Design (ASD) Process: - Apply service loads with no load factors - Assume linear elastic analysis of structure - Calculated stresses shall not excee

Question During piling works, normally founding levels of bored piles are definite by using total core recovery or rock quality designation (RQD). Are there any problems by

Q. Vibration in structures - resilient bearings? When railway tunnels are built close to buildings, ground-borne vibration is transmitted to buildingsthrough compression and sh

Beam of arbitrary cross-sectionsubjected to couples M Bending moment at any sectionis M Consider segment of beam subtended by angle θ Some fibres will shorten e.g. ABand o