Machine language - first generation language, Electrical Engineering

Machine Language ( First Generation Language)

As we have  already discussed that all digital  circuits  can identify  only two  states which  can be specified  by 0 and i hence  microprocessor  also can be instructed only  using  some  combination of 0 and 1 such a language which  comprises of 9 and 1  only is  called machine  language as it is used to instruct a machine initially there  was no alternative than  using  machine  language  as it was the only language  available. Programs were written using machine  language in the early  age of computers.

Posted Date: 4/4/2013 1:22:24 AM | Location : United States







Related Discussions:- Machine language - first generation language, Assignment Help, Ask Question on Machine language - first generation language, Get Answer, Expert's Help, Machine language - first generation language Discussions

Write discussion on Machine language - first generation language
Your posts are moderated
Related Questions
Q. What is Time Switches? Principle of a time switch is displayed in Figure. It connects an incoming n channel PCM highway to an outgoing n channel PCM highway. As any incoming

Metering Techniques The techniques of metering could be categorized depending upon the voltage at which consumers are fed as: 1. LT (Low Tension) Metering, and 2. HT (Hi

Q. What is the advantage of a two-stage overloaded RC coupled amplifier over a single stage one? What are it's uses? It is a frequently encountered configuration. Here, the tra

Q. Analyze Diode circuit with RLC load? Consider a diode circuit with an RLC load, as shown in Figure, and analyze it for i(t) when the switch S is closed at t = 0. Treat the d

commutator in d.c machine acts as... what????

Q. Show Binary to Octal Conversion? It is simple to convert from an integer binary number to octal. This is accomplished by: Break the binary number into 3-bit secti

Q. A balanced electrical industrial plant load of 9.8 MW with 0.8 lagging power factor is supplied by a three-phase 60-Hz system having a maximum rating (load-carrying capacity) of

Q. An RL series circuit carries a current of 0.02 cos 5000t A. For R = 100  and L = 20 mH, find the impedance of the series combination and determine the voltage across the series

Register Addressing In this  mode the operand are microprocessors  registers only i, e  the operations is performed  within  various  registers of the  microprocessors  only.

Mode 2 In this  mode transistor  gets turned off by  the negative output  of PWM  current  flows  through  inductance L diode D then  divide into two  parts one flows through