Longitudinal strain produced - hollow cast iron cylinder, Mechanical Engineering

Longitudinal strain produced - hollow cast iron cylinder:

A hollow cast iron cylinder 4 m long, 300 mm is the outer diameter, and thickness of metal 50 mm is subjected to central load on top when standing straight. The stress generated is 75000 kN/m2. Assume that the Young's modulus for cast iron as 1.5 x 108 KN/m2  find out Longitudinal strain produced ?

Outer diameter, D = 300 mm = 0.3 m Thickness, t = 50 mm = 0.05 m

Length, L = 4 m

Stress produced, σ = 75000 kN/m2

E = 1.5 x 108 kN/m2

Here diameter of cylinder, d = D - 2t = 0.3 - 2 × 0.05 = 0.2 m

Longitudinal strain produced, e :

By using the relation,

Strain, (e) = stress/E = 75000/1.5 x 108 = 0.0005                           .......ANS

 

Posted Date: 10/20/2012 7:59:40 AM | Location : United States







Related Discussions:- Longitudinal strain produced - hollow cast iron cylinder, Assignment Help, Ask Question on Longitudinal strain produced - hollow cast iron cylinder, Get Answer, Expert's Help, Longitudinal strain produced - hollow cast iron cylinder Discussions

Write discussion on Longitudinal strain produced - hollow cast iron cylinder
Your posts are moderated
Related Questions
COMPRESSOR MOSTLY USED FOR SUPERHEATING OF IC ENGINES IS CALLED ----------COMPRESSORS

How does the maximum the 10'''' flange horizontal offset allowable.

Determine the RF on the scale: A length of 3 km on the ground is presented via 6 cm length on a map. Determine the RF on the scale on that it has been drawn.  RF = Length o

Pure Torsion: What do you mean by pure Torsion?                                                                                                       In general two typ

assumptions made in deriving a bending formula


Illustrate the GKS system The user communicates with the graphic system via his program. The GKS system is embedded in the user program by an application-oriented layer and a l

Calculate Additional force required to maintain equilibrium: Fo r the system shown in figure find the additional single force required to maintain equilibrium. Sol.: L

The extent of a hazardous area depends on the rate of release, ventilation conditions, and fluid properties and is defined by the relevant regional or country standards. The pot

Technical Limitations of Extension of screw conveyor Technical Limitations: Breakdown of hinged joint at intermediate condition of link. ?Not proper extension of coaxi