Locomotive boiler, Mechanical Engineering

LOCOMOTIVE BOILER:

It is horizontal, natural circulation, fire tube boiler. It can generate steam at the rate of 7000 kg/hr. at pressure of up to 2.5 Mpa. Earlier it was used in railways for traction 

Posted Date: 10/20/2012 2:53:21 AM | Location : United States







Related Discussions:- Locomotive boiler, Assignment Help, Ask Question on Locomotive boiler, Get Answer, Expert's Help, Locomotive boiler Discussions

Write discussion on Locomotive boiler
Your posts are moderated
Related Questions
Analyse the beam: Analyse the beam illustrated in Figure and draw the SFD, BND & thrust diagram. Situated the point of contraflexure, if any. Figure Solution

Ancillary Railway Structures: Overhead Transmission Lines When the line is electrified, the electric loco has to pick up the electric current from a cable that runs


Q. Define Conceptual Engineering Phase for project? The primary objective of this stage is to include and clearly define the economic feasibility of the project, sensitivity to

Service duty point: 3 m3/h Backwash duty point: 9 m3/h Part (a) What is the speed of the pump to achieve the service and backwash flow rates ? Part (b) What would be the best

Q. What is Pressure Testing? Pressure test shall be performed after completion of all welds and the PWHT of the boiler. Prior to final inspection and pressure test, the insi

Explain the Single Cast Component Auger Material for Single Cast Component Auger: Either Ni-Cr or Cast iron Length of components: 1250 mm. Outer Diameter of Auger compone

Find out the intensity of the external pressure: A thick cylinder of 0.5 m external diameter & 0.4 m internal diameter is subjected simultaneously to internal & external press

a) Answer the following equations by Factorization method 10x+y+z =12 ; 2x+10y+z =13 ; 2x+2y+10z=14 b) Apply Gauss-Seidal Iteration method to solve the equations 20x+y-2z

Give a generalized definition of factor of safety. Illustrate the factors responsible for Un-certainities in design necessitating a suitable factor of safety. How is ‘factor of saf