Lock Clip Came out from Rear Brake Drum (Backplate) , Other Engineering

A type of brake used to keep the vehicle from rolling when it is parked. The standard
Parking brake locks the rear wheels to keep the car from moving. Parking brake cable is fixed in back plate of brake drum by wire clip. Wire clip is used to hold parking brake in brake drum.
Problem:
But due to relative motion and vibration of vehicle the wire clip is fly away and loose the parking brake cable from brake drum.
As per stack analysis considering worst condition, we have found 0.45mm clearance between wire clip & brake cable.
Because of that there is no gripping between wire clip & parking brake cable.
Solution Required:
1- Parking brake cable should not come out from rear brake drum.
Constraints:
1- Easy fitment of wire clip with parking brake cable.
Posted Date: 4/11/2012 4:16:48 PM | Location : United States







Related Discussions:- Lock Clip Came out from Rear Brake Drum (Backplate) , Assignment Help, Ask Question on Lock Clip Came out from Rear Brake Drum (Backplate) , Get Answer, Expert's Help, Lock Clip Came out from Rear Brake Drum (Backplate) Discussions

Write discussion on Lock Clip Came out from Rear Brake Drum (Backplate)
Your posts are moderated
Related Questions
QUESTION 1 a) Describe any three properties of Mortars b) Each combination of coarse and fine aggregates has a specific water demand for a given mix fluidity or slump. What

A W12x40 beam is heated to 760°C. Answer the following questions. What is the W/D factor for sprayed protection? What is the W/D factor for box type protection? What is the spe

Engineering Signals A signal is a variation of a measurable quantity that conveys information about the behaviour of a system. • A signal can depend upon a single variable o

Briefly describe a simple method of estimating summer outside air conditions for the design calculations of an air conditioning scheme. If a more accurate assessment of heat gains


Q. What is the purpose of :          (i) Sizing,                  (ii) Coining operations in powder metallurgy,         (iii) Infiltration,           (iv) Impregnati

an iron ring with amean dia of 50 cm has an air gap of 1mm awinding of 200 turns if the permeability of the iron is 400 when a circuit of 1.25A flows through the coil find the flux

Explain the formation of newton''s ring in reflected light. Prove that the radius of the bright rings are proportional to the square root of the positive odd interger

Compressor characteristics: When a compressor is designed it is essential to establish the points at which it is likely to surge. Tests are carried out to determine the relati

Circuit that is able to convert an AC voltage signal into DC voltage signal