Load resistor , Electrical Engineering

a) Include a Smoothing Capacitor to the Rectifier circuit and calculate the Output Voltage and Frequency

b) Include a 47Ω Load Resistor and sketch the schematic diagram of the circuit that you now have connected to the transformer box.

 

Posted Date: 3/28/2013 1:34:28 AM | Location : United States







Related Discussions:- Load resistor , Assignment Help, Ask Question on Load resistor , Get Answer, Expert's Help, Load resistor Discussions

Write discussion on Load resistor
Your posts are moderated
Related Questions

Draw the circuit of transistor in the common base configuration. Draw the Active, saturation and cut-off region. List the characteristics of Ideal Op-Amp. Sketch the pin diagram

What is memory paging? The memory paging mechanism located inside the 80386 and above permits any physical memory location to be assigned to some linear address.

For an operating point half way up the parallel section and the discharge valve and the discharge fully open, design a proportional only controller which will give closed loop dyna

Why is the signal first attenuated and then amplified?

Q. A simple parallel resonant circuit with L = 50 µH is used to performthe frequency selection. The circuit is to be tuned to the first station at a frequency of 1000 kHz. In order

Explain temperature dependence of electrical resistivity and conductivity in semiconductors. The electrical conductivity of the semiconductors changes considerably with temper

Explain Limit Signal Spectrum to Prevent Aliasing? The sampling frequency should at least be two times that of the highest frequency in the incoming signal to avoid aliasing. T

Explain the Alphanumeric Coding - bcd to decimal conversion? For the inherently binary world of computer, it is necessary to put all symbols, letters, numbers, and so on into bin

Low Investments in Transmission and Distribution System The investment on T&D system in our country has commonly been lower than that on generation. It is hugely believed in