List all application layer and transport layer protocols, Computer Networking

a)  A host is sending a HTTP request to a HTTP server. In the table below, propose a correct set of source and destination port numbers for segments sent from host to server and from server to host resulting from this request.

Segment                              Source port number                       Destination port number  

from host to server  

from server to host

b)  List all application layer and transport layer protocols that will be used by a host to download a web page from a server. Assume that the IP address of the server is not known to the host.

Note: the number of cells in the table does not have to match the number of protocols you will list.

Application protocols                                     Transport protocols

Posted Date: 3/25/2013 6:15:40 AM | Location : United States







Related Discussions:- List all application layer and transport layer protocols, Assignment Help, Ask Question on List all application layer and transport layer protocols, Get Answer, Expert's Help, List all application layer and transport layer protocols Discussions

Write discussion on List all application layer and transport layer protocols
Your posts are moderated
Related Questions
what is the differnce between noise and distortion

Cost Involved in Inter-Processor Communication As the data is assigned to many processors in a parallel computer while implementing a parallel algorithm, the processors might

Compute the shortest path from t to all network nodes.

Verify VLANs and trunking. Use the show ip interface trunk command on S1 and the show vlan command on S2 to determine that the switches are trunking correctly and the proper VL

can you help me convert binary into decimals?

Discuss about the similarity of Intranets to the Internet The ease of use of the end user would be the most noticeable because of the similarity of Intranets to the Internet. S

if the signal input to an amplifier is 0 dBm what is the power output in mW if the gain of the amplifier is 20 dB ?


Network Problems Q1  Consider the single-sender CDMA example in Kurose & Ross. What would be the sender's output (for the 2 data bits shown), if the sender's CDMA code were (

- Lost as well as delayed ACKs - Bidirectional transmission both side needs both sending and receiving windows Note: In selective repeat ARQ the size of the sender and rece