Line of action of force, Mechanical Engineering

Line of action of force:

Sol.: The direction of force along the straight line through its point of application, in which force tends to move body to which it is applied. This line is called as line of action of the force.

 

 

Posted Date: 10/16/2012 1:09:00 AM | Location : United States







Related Discussions:- Line of action of force, Assignment Help, Ask Question on Line of action of force, Get Answer, Expert's Help, Line of action of force Discussions

Write discussion on Line of action of force
Your posts are moderated
Related Questions
Types Of Polymerisation When some of bifunctional molecules connect in a chain structure, the reaction is termed as addition polymerisation.  However, these polymerizations do

Determine the maximum permissible axial load: In an open coiled spring of 10 coils the stresses because of bending and twisting are 120 N/mm 2 and 150 N/mm 2 respectively wh

Effect of parameters in flash butt welding Flashing Feed Rate : If excessive, there is a probability of the parts freezing together without welding. If this is insuffic

Q. Combustion Chamber and Radiant Section? The combustion chamber and the radiant heat transfer section of the Steam Generators shall be a horizontal, multiple pass arrangement

Gears interchange between Y2K and non Y2K model: Check for mixing of Y2K and non Y2K gears by seeing the identification marks provided on the gears.

Q. Design evacuation systems for plant? The plant will have designated Muster areas where personnel can go during an emergency and be accounted for and from which they can then

Ratio of applied stress and yield stress: What should be the ratio of applied stress, s, to yield stress s Y in a large thin plate so that plastic spread along lint of crack

Thermodynamics. Justify that it is the science to calculate energy, energy and entropy. Sol : Thermodynamics is science which deals with conversion of heat into mechanical e

Polyhedra and Euler's Formula The b-rep of a polyhedra that are holomorphic to a sphere are topologically valid if they satisfy the following equations : F - E + V - L = 2 (

Determine the Machining Time in Milling Operation An HSS slab mill of 100 mm diameter and 150 mm width is used on a Horizontal milling machine to mill C50 steel. The milling c