Level of safety organization, Mechanical Engineering

Level of Safety Organization

This level comprises representatives of safety departments working at shop floor level or along with workers. The personnel will in fact implement safety procedures, train workers on procedures, guide them to adoption of procedure. They will give all support for maintenance of environment and its preservation. Very significantly the personnel at this level will conduct safety drills.

Posted Date: 1/25/2013 6:17:59 AM | Location : United States







Related Discussions:- Level of safety organization, Assignment Help, Ask Question on Level of safety organization, Get Answer, Expert's Help, Level of safety organization Discussions

Write discussion on Level of safety organization
Your posts are moderated
Related Questions
DESIGN FACT DATA: ?A) Torque capacity for traction motor of screw conveyor-1660 N-m. ? B) RPM of Traction motor-115 rpm. ? C) Pressure require for operating the telescopi

Ratio of belt tension: For Open belt drive:   Angle of contact (θ) for larger pulley = ∏ + 2α Angle of contact (θ) for smaller pulley = ∏ - 2α For cross belt drive:

Describe the following key terms: (i) Stream Line (ii) Path Line (iii) Streak Line (iv) Stream Function (v) Potential flow function (vi) Flow net

Q. What is Pre-fabricated buildings? Buildings: Pre-fabricated buildings shall be as per specification GS-904-0520 and, when provided, conceptual drawings prepared by Engine

Average force of resistance: A gun weighing 500 kN is utilized to fire a shell weighing 10 kN in a horizontal direction with a velocity of 500 metres/sec. With what initial ve

Discover the maximum thickness required: A thin cylindrical vessel of 2 m diameter and 4 m length having a particular gas at a pressure of 1.65 N/mm 2 . If the allowable tensi

Define different regimes of boiling and depict their ranges on a excess temperature curve us heat flux. Also distinguish between laminar film condensation and dropwise condensation

Define different types of properties: Sol: For defining any system certain parameters are needed. Properties are the observable characteristics of system, which can be emplo

In an I.C. engine operating on the Dual combustion cycle, the temperature of the working fluid (air) at the beginning of compression is 27ºC. The ratio of the maximum and minimum p

A load of 2MN is applied on a short concrete column 500 mm x 500 mm. The column is reinforced with four steel bars of 10 mm diameter, one in each corner. Evaluate the stresses in t