Key words used in road under special conditions, Mechanical Engineering

Keywords used in appropriate technology:

Hill Roads : Roads in hilly and mountainous terrain.

Landslides : The slippage of mass of hill face.

Retaining Walls : Structures constructed to retain the fill portion in hill roads.

Breast Walls : Structures constructed to buttress uphill slopes of hill roads.

Check Walls : Small retaining structures provided in series to arrest landslides.

Gabion Walls : Walls made up of stones encased in wire mesh or geogrid cages.

Parapet Walls : Walls constructed for protecting vehicles from falling into the valley in hill roads.

Marshy Area : Area which is water-logged and swampy.

Sand Drains : Vertical drains constructed to facilitate upward movement of water from underlying saturated soil.

Dunes : Mounds formed by deposit of wind-blown fine sand in deserts.

Gravel Roads : Roads having a surfacing of naturally occurring or blended material.

Appropriate Technology : Technology using equipment like tractors, disc harrows, tillers, rooters and rotavators.

Posted Date: 1/22/2013 6:22:11 AM | Location : United States







Related Discussions:- Key words used in road under special conditions, Assignment Help, Ask Question on Key words used in road under special conditions, Get Answer, Expert's Help, Key words used in road under special conditions Discussions

Write discussion on Key words used in road under special conditions
Your posts are moderated
Related Questions

Q. Soil conditions for plant layout? Soil conditions affect the foundation requirements, drainage, type of substructure used and may limit the size and shape of the facility. T

If Steering is Heavy Causes of Problem Remedy Steering head adjuster too tight Damaged steering cones or steel ball

Q. Show the Coating Application? Immediately following surface preparation, the cleaned pipe shall be uniformly preheated by a non-contaminating method to the application tempe

(a) Classify the two wheeler engines. (b) Define the following components and their uses in engine with the help of engine diagram. (i) Crankcase (ii) Piston and Piston pi

A steel pipe with 50 mm OD is covered with a 6.4 mm asbestos insulation followed by a 25 mm layer of fiber-glass insulation [K = 0.0485 Wmk]. The pipe temperature is 393 K and the

PART A A new process plant for ore processing is currently being planned. The design is only in the first stage. However, three requirements have already been clearly stated:

Hill Roads: Alignment Selection and Geometric Design Standards Here, you have already learnt how an alignment of a hill road has to be selected. The selection of a g


Determine the ratio between moment and load: Any close coiled helical spring of circular section extends 1 mm while subjected to an axial load of W and then given an angular r