Key words related to railway line, Mechanical Engineering

Keywords related to railway line:

Railway Station : A facility along a railway line where trains stop and passengers are serviced, and cargo is handled.

Platform : A facility where trains stop and passengers entrain and detrain.

Marshalling Yard :  A facility where goods wagons are sorted out for being dispatched too different stations and formed into trains.

Loading Ramp : A ramp for loading road vehicles to a railway wagon.

Engine Shed (Loco Shed)  : A shed for repairing and servicing railway engines.

Culverts : Small cross-drainage works.

Bridges : Large structures cross rivers.

Tunnels : Structures cut through hills for accommodating railway lines.

Laying of Track : The operation of laying a railway track on the (Plate Laying)     earthen formation.

Maintenance of Track : The operation of maintaining railway track in good condition.

Permanent Way Inspector : The staff in charge of inspecting and maintaining railway line.

Track Renewal : The operation of completing renewing an overaged track by a new one.

Posted Date: 1/23/2013 1:26:49 AM | Location : United States







Related Discussions:- Key words related to railway line, Assignment Help, Ask Question on Key words related to railway line, Get Answer, Expert's Help, Key words related to railway line Discussions

Write discussion on Key words related to railway line
Your posts are moderated
Related Questions
Determine the loss-by-defect and loss-by-dispersion Given, Annual production = 1,00,000 units Specification = 20 ± 4  i.e. m = 20, Δ = 4 Cost of repairing or resetting a


Determine the isentropic flow through the nozzle: In an isentropic flow through the nozzle, air flows at rate of 600Kg/hr. At inlet to the nozzle, the pressure is 2Mpa and te

If Low Resistance or Very High Current in Primary Coil Circuit Causes of Problem Remedy Primary ignition coil short circuited

Once the total volume of an individual vessel has been established the detailed dimensions or mechanical design can be performed. Much of this is based on "Rules of Thumb"  built f


can you help me to do my project on machine design,it is specific project with calculation and some draw.

how we made parts of engine

Q. Cold service insulation on pipe? Factory fabricated sectional pipe insulation shall be applied in staggered joint construction. On multiple layer construction, all joints sh

Variables used in WPS Depending on their influence on obtaining a desired weldment, the welding variables are then classified and listed. Some of them are listed as "Essential