Input output, Electrical Engineering

Input output

The parallelogram symbol  is used to represent the input output  process as shown  below.



Posted Date: 4/5/2013 3:18:24 AM | Location : United States

Related Discussions:- Input output, Assignment Help, Ask Question on Input output, Get Answer, Expert's Help, Input output Discussions

Write discussion on Input output
Your posts are moderated
Related Questions
Explain the NAND Gates - Microprocessor? The NAND GATE is a AND gate with the output inverted. Consequently the outputs of a NAND gate would be the opposites of the outputs of a A

Q. Draw and explain diode clipping circuit ? A diode clipping circuit can be used to limit the voltage swing of a signal. Clipper circuits are used to clip a portion of the w

I''m trying to design ADC using MAX1198 and DAC using IDAC in Multisim 12 but none of them are working. I need some help in this regard

Question: (a) Consider the following RC admittance function: (i) If the function is to be realised using the Cauer II Form, find the values of the different components

Q. If a feeder circuit-breaker trips, what action is needed? Ans: First isolate the faulty feeder check the faulty area on which fault the breaker was tripped (open circuit,

Q. Block schematic diagram of SS7? Levels are as below: Level 1: The Physical Layer Level 2: The Data Link Level Level 3: The signaling network level Level 4: The User Pa

Q. Describe Common-Mode Rejection Ratio ? When there is a common-mode input voltage, i.e., when the input signals are equal and greater than zero, the output voltage of an idea

Questions: a) One common characteristic of Embedded Systems is that they need to be dependable. Name and describe any three aspects which encompass dependability. b) Name

Critical Rate of  Rise of Current The maximum  rate of  increase of current  during  on state  which  the SCR  can tolerate is called  the critical rate of rise  of current  f

A relay is essentially an electromechanical switch that opens and closes electrical contacts. A simplified relay is represented in Figure. It is required to keep the fenomagnetic p