Inlet channel of the exchanger, Mechanical Engineering

Assignment Help:

Q. Inlet channel of the exchanger?

The inlet channel of the exchanger shall be designed to minimize flow turbulence and erosion of the refractory liner and the tube inlet area. The latter shall be protected by ferrules.

Channels shall be completely drainable. The outlet channel shall have a liquid sulfur drain.

Access for tube replacement and refractory maintenance shall be facilitated by removal of the bolted cover of the outlet channel.

Hinged 610 mm (24" NPS) clear manways for inspection and maintenance of refractory liner, tube ferrules, and tube-to-tubesheet joints shall be provided in the inlet and outlet channels. Manways shall have removable refractory plugs.


Related Discussions:- Inlet channel of the exchanger

What are the alluvial sediments, What are the Alluvial sediments Alluvi...

What are the Alluvial sediments Alluvial sediments are characterized by stratification or layering and fine grained soil layers have higher compressibility as compared to coars

Process of corrosion in bfw tank, Q. Process of Corrosion in BFW Tank? ...

Q. Process of Corrosion in BFW Tank? The feed to the BFW Tank is hot and will be flashing when it enters the tank. The vapours will be corrosive when the tank is open to atmosp

Thrust and pressure, Thrust: The net force exerted by a liquid on any shie...

Thrust: The net force exerted by a liquid on any shield in contact with it, is called as thrust of liquid. Pressure:  The thrust operated by a liquid per unit area of the fie

Kinematic equations, A projectile is fired with a velocity u at the entranc...

A projectile is fired with a velocity u at the entrance A of a horizontal tunnel of length L and height H. Determine the minimum value of u and the corresponding angle \theta for w

Capacity planning, Capacity Planning: This unit defined different ways...

Capacity Planning: This unit defined different ways to measure capacity, set up maximum capacity, and calculate capacity utilization. The long-term and short-term strategies t

Find out extension, Find out extension: Q: A bar having length 25mm h...

Find out extension: Q: A bar having length 25mm has varying cross section. It carries load of 14KN. Find out extension if cross section is given by (6 + x 2 /100) mm 2

First gear position -Shifting of Gears , First Gear Position : When gear M...

First Gear Position : When gear M1 is in mesh with gear C1 then this is first gear drive position. The gear C1 is freely attached to counter shaft, so gear C1 itself cannot rotate

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd