Industrial Automation, Electrical Engineering

1. Write the Boolean expression and draw the gate logic diagram and typical PLC ladder logic diagram for a control system wherein a fan is to run only when all of the following conditions are met:
? Input A is OFF
? Input B is ON or input C is ON, or both B and C are ON
? Inputs D and E are both ON
? One or more of inputs F, G, or H are ON
Posted Date: 4/2/2016 11:46:08 AM | Location : Ethiopia







Related Discussions:- Industrial Automation, Assignment Help, Ask Question on Industrial Automation, Get Answer, Expert's Help, Industrial Automation Discussions

Write discussion on Industrial Automation
Your posts are moderated
Related Questions
Give the properties and application of brass. Brass - It is an alloy of copper and zinc with 60 percent copper and 40 percent zinc. Its electrical resistivity of Brass is 7.0

A 2300-V, three-phase, wye-connected, round rotor synchronousmotor has a synchronous reactance of 3 per phase and an armature resistance of 0.25  per phase. The motor operates on

Q. Write a short note on the frequency response of a R-C coupled amplifier. At low frequencies ( , the reactance of coupling capacitor Cc is quite high and hence very small pa

equivalent circuit for transistor using h parameters

Prepaid Metering Prepaid metering is the state of art for single and three-phase although current metering, and should be implemented through utilities desirous of protecting

Q. Athree-phase, 600-kVA, 2300:230-V,Y-Ytrans- former bank has an iron loss of 4400 W and a full- load copper loss of 7600 W. Find the efficiency of the transformer for 70% full lo

Definition of  Magnetism Magnetism is explained as the force produced by charge particles (electrons) of magnet. A magnet is a material that obtained a magnetic field.

The  programming  Model of 8085 Microprocessor The programming  model  of 8085 microprocessor is  shown in figure  below in this  model  various 8 bit  and 16  bit registers a

Explain Load Flow Analysis The method commonly used for load flow analysis is the nodal analysis. The nodal analysis method is given in many books on circuit theory and is base

commutator in d.c machine acts as... what????