Induction pressure welding, Mechanical Engineering

Induction Pressure Welding

In this process, the current is induced by high frequency induction process in the job. Due to electrical induction the job is heated. When a suitable temperature is reached, the weld is consolidated by a forging action of the joint. This is generally used in manufacture of boiler tubes. A very high level of productivity can be obtained with this process.

 

Posted Date: 9/13/2012 6:21:56 AM | Location : United States







Related Discussions:- Induction pressure welding, Assignment Help, Ask Question on Induction pressure welding, Get Answer, Expert's Help, Induction pressure welding Discussions

Write discussion on Induction pressure welding
Your posts are moderated
Related Questions
Creating 3-d solid models Two basic approaches to create solid models are :    (i)  Constructive solid geometry (CSG or c-rep), and (ii)  Boundary representation (b-rep).

Let B be the number of bicycles formed  from F bicycle frames and T tires. Each bicycle require exactly two tires and one frame. a. Sketch the isoquants for bicycle production.

Illustrate the process of knock in C.I engines and compare it with S.I. engine knock. What is Octane rating of C.I. engine fuel. What is the difference between chemical delay and p

Drive the expression for critical pressure ratio for steam nozzle and illustrate critical pressure. Air flows in a 200cm 2 duct at a velocity of 180 m/s, a pressure of 119 KPa

INTREPRETATION OF DEFECTS Intrepretation is an important factor is controlling the quality of the product on economic levels. Sometimes for want of proper decision, proj

Find out the deflection: Find out the deflection (vertical) at a distance 'a' from the tip in Example Solution As in this case there is no load at the point where the

Q. What is Clad plate and overlay welding? Strip back cladding on clad plate a minimum of 5 mm (3/16") from the edges of weld preparation before welding on the backing plate.

If "o" ring is found to be leaking or oil seal is found to be leaking check as mentioned: If "O" ring found to be leaking change "O" rings. If oil seal found to be leaking check o

Carbon nanotubes (CNTs) with low weight (density = 1.3 g/ cm^3), high tensile strength (50 GPa), and modulus of elasticity (1 TPa) in the axial direction have been touted as the st

Explain construction and working process of newton''s ring