Important section of fly-overs and underpasses, Mechanical Engineering

Important section of fly-overs and underpasses:

Culverts : A structure having a waterway upto 5 m.

Minor Bridge : A structure having a waterway of 6-30 m.

Medium Size Bridge : A structure having a waterway of 30-100 m.

Major Bridge : A structure having a waterway above 100 m.

Posted Date: 1/23/2013 12:29:25 AM | Location : United States







Related Discussions:- Important section of fly-overs and underpasses, Assignment Help, Ask Question on Important section of fly-overs and underpasses, Get Answer, Expert's Help, Important section of fly-overs and underpasses Discussions

Write discussion on Important section of fly-overs and underpasses
Your posts are moderated
Related Questions
Q. Show Leak Area Preparation? Clearly mark the location of the leak on the flange with a permanent marker. Notes: 1. Depressurizing hydrocarbon lines in non-emergency event

A shaft is supported on bearings A and B, 800 mm between centres. A 20° straight tooth spur gear having 600 mm pitch diameter, is located 200 mm to the right of the left hand beari

WELDING VARIABLES The following major process variable play an important role in shaping the weld bead and the resultant weld metal in submerged arc welding: a. Welding cu

Illustrate in brief the types of power plant? Illustrate the factor to be considered for site selection in hydro power plant? a) Compare stream power plant with hydro power p

Isolated and Combined Footings Individual columns are generally supported on isolated footings. A typical isolated footing is shown in Figure. This arrangement is suitable when

On the Moodle site just below the assignment you will find data from a slow sine sweep test conducted on a car on a "four-post" road simulator for the frequency range 0 to 20 Hz in

One can increase the toughness of a ceramic material by introducing fibers to the structure of the ceramic and create a ceramic-matrix composite. However, unlike other fiber-reinfo


Determine the relative error in the function y = ax 1 m1 x 2 m2 ........x n mn If u = 4x 2 y 3 / Z 4 and error in x, y, z be 0.a, compute the relative maximum error in u ta

Calculate the principal dimensions of a cone clutch faced with leather to transmit 30 KW at 750 r.p.m. from an electric motor to an air compressor. Draw a section front view of the