How to add a wait state when creating a verification point, Computer Engineering

1. Start to make the verification point.

2. In the confirmation Point Name dialog box, select Apply wait state to confirmation point.

3. Type values for the following options: Retry every - How often Robot retries the confirmation point during playback. Robot retries until the confirmation point passes or until the timeout limit is reached.

Timeout after - The maximum amount of time that Robot waits for the confirmation point to pass before it times out. If the timeout limit is reached and the verification point has not passed, Robot enters a failure in the log. The script playback either continues or stops based on the setting in the Error Recovery tab of the GUI Playback Options dialog box.                              

 

 

Posted Date: 4/4/2013 6:15:20 AM | Location : United States







Related Discussions:- How to add a wait state when creating a verification point, Assignment Help, Ask Question on How to add a wait state when creating a verification point, Get Answer, Expert's Help, How to add a wait state when creating a verification point Discussions

Write discussion on How to add a wait state when creating a verification point
Your posts are moderated
Related Questions
Rational ClearQuest is a change-request management tool that tracks and handles defects and change requests all through the development process. With ClearQuest, you can manage eac

Can the size of an array be declared at runtime?              No, the size of an array can't be declared at run time, we always require to mention the dimensions of an array at

Graphics adapters: Video card converts digital output from computer into an analog video signal and transmits the signal through a cable to monitor also known as a graphics ca


What are the special features of Direct RDRAM? It is a two channel Rambus It has 18 data lines intended to transfer two bytes of data at a time There are no divide

10 k Ohm pulls up on MCLR so that the ICD can force 0, +5, +13 volts on this pin. RB6 and RB7 used for PGC and PGD respectively between target and ICD2 module. Some of the requi

The alignment of a type 'c' field in a report is? ? Left Aligned.

The Standard C Library function is removing. (This is thus one of the few questions in this section for which the answer is not ''It's system-dependent.'') On older, pre-ANSI Unix

First we must go to bios and should check boot sequence,local add statusOr we should check RAM & check h.d.d cable. check cd writer for cd or dvd

Describe the three mapping techniques used in cache memories with suitable Example. The cache memory is a fast memory that is inserted among the larger slower main memory and t