Horizontal hinge, Mechanical Engineering

2 x 2 m square gate opens clockwise on a horizontal hinge located at point A, which is 100 mm below the centroid of the gate. The gate sits against solid rubber blocks which create an effective pressure seal. The gate is designed to open from the top when the water exceeds a certain depth. To what depth h can the water rise without the gate opening at C?

310_Horizontal hinge.png

Posted Date: 4/1/2013 1:46:28 AM | Location : United States







Related Discussions:- Horizontal hinge, Assignment Help, Ask Question on Horizontal hinge, Get Answer, Expert's Help, Horizontal hinge Discussions

Write discussion on Horizontal hinge
Your posts are moderated
Related Questions
(a) Illustrate the First Law of Thermodynamics for a closed system undergoing a cycle. (b) A piston and cylinder machine contains a fluid system which passes through a complete

Q. W rite different relations used in belt drive. Sol: Let: D 1 = Diameter of driver N 1 = Speed of the driver in Rotation per minute D 2 = Diameter of the driv

Inspection of Electrical Equipment STEPS All electrical equipment are checked for proper functioning. The starting and lighting of the motorcycle should be prope

Describe in detail the following mechanisms : (a) Pendulum Pump (b) Crank and slotted lever mechanism Explain in detail the following mechanisms : (a) Elliptical Tramme

Q. Explain about Postweld Heat Treatment? Pressure vessels shall be postweld heat treated per applicable sections, in accordance with applicable material specifications or when

Efficiency Test on Sand Blasting:             After the study on sand blasting, the result was acceptable and the next step is planning to make order for new machine and searc

(a) A member ABC is formed by connecting a steel bar of 20mm diameter to an aluminium bar of 30 mm diameter, and is subjected to forces as shown in figure. Evaluate the total defor

Submerged Arc Welding   Single pass filler welds upto (8.0 mm) maximum and groove welds made with a single pass or a single pass each side, may be made using an E7os-x elect

Discover the fixing torques set up at the ends of the shaft: A solid shaft 6.5 m long is securely fixed at each of the end. A torque of 91 Nm is applied to the shaft at a sect

Inertia : The clutch rotating part should have minimum inertia. Otherwise, when the clutch is released for gear changing, the clutch plate will keep on spinning, causing hard shif