Hill roads - road under special conditions, Mechanical Engineering

Hill Roads:

Alignment Selection and Geometric Design Standards

Here, you have already learnt how an alignment of a hill road has to be selected. The selection of a good alignment results in economy in construction and subsequent maintenance. The geometric design standards have also been discussed previously. Here, we shall discuss some special features of hill roads.

Posted Date: 1/22/2013 5:43:15 AM | Location : United States







Related Discussions:- Hill roads - road under special conditions, Assignment Help, Ask Question on Hill roads - road under special conditions, Get Answer, Expert's Help, Hill roads - road under special conditions Discussions

Write discussion on Hill roads - road under special conditions
Your posts are moderated
Related Questions
Lean Mixture: It generally ranges from approximately 15 : 1 to 17 : 1. By the use of this fuel, engine runs for higher economy.

Compute the intensity of normal stress: A uniform steel bar of 2 cm × 2 cm area of cross section is subjected to axial pull of 40000 kg. Compute the intensity of normal stres

The cockpit of a jet plane flying at a speed of 1200 km/hr is to be cooled by simple air cooling system. The cockpit is to be maintained at 25 0 C and pressure in the cockpit is 1

The EV is to be used for city transportation, it should carry a maximum total load of 325 kg (passengers and cargo). The battery back used will be 365 kg, 44 kilowatt hours lithium

Tension in the strings: Sol.: When weight is attached to string then it will be in tension. The diagrams are shown below to describe this particular concept.

Define Trunnion Jig These jigs are used for drilling holes on very large or odd. 1. Figure shows the shaped parts from different sides. Figure: Trunnion

Force required to start the roller: A roller shown in the figure given below is of mass 150Kg. What force T is required to start the roller over block A ? Sol.: Let

Question Suppose T 1 and T 2 are independent and identically distributed Exponential variables with common hazard λ. What is the density of T = T 1 + T 2 ? What is the E(T-1

what is feathering system in turbo prop type aircraft

I have got a rusted chassis of a car.I wonder if you can estimate the remaining strength in a longitudial steel beam 6 cm wide x 12 height.