Hilda output - externally initiated signals , Electrical Engineering

HILDA ( Output)

It is  called hold acknowledge signals it is active  high  i e it  goes high when  microprocessor receives HOLD signal.

 

 

Posted Date: 4/4/2013 3:40:19 AM | Location : United States







Related Discussions:- Hilda output - externally initiated signals , Assignment Help, Ask Question on Hilda output - externally initiated signals , Get Answer, Expert's Help, Hilda output - externally initiated signals Discussions

Write discussion on Hilda output - externally initiated signals
Your posts are moderated
Related Questions
Using the BC548B BJT transistor amplifier biasing circuit of Lab 2 build an amplifier with the voltage gain of  |A V | = 30 v/v ± = 10%. Measure all necessary parameters of the amp

Electrical power Power P in an electrical circuit is given by the product of potential difference V and current I. The unit of power is the watt, W.


What is the signal classification of 8085 All the signals of 8085 can be classified into 6 groups Address bus Data bus Control and status signals Power supply and f

Q. Computer-aided circuit analysis using MATLAB ? This text does not teach MATLAB; it assumes that the student is familiar with it through previous work. Also, the book does no

What is the use of terminal count register? Each of the four DMA channels of 8257 has single terminal count register. This 16-bit register is used for ascertaining that the dat

Q. A synchronous motor operates continuously on the following duty cycle: 50 hp for 8 min, 100 hp for 8 min, 150 hp for 10 min, 120 hp for 20 min, and no load for 14min. Specify th

Explain working of Phase Shift Oscillator? Figure shows a phase shift oscillator. Here the combination of ReCe provides self bias for the amplifier. The phase of the signa

State by inspection (i.e. without performing any formal analysis) all you can about each of the periodic waveforms shown in FIGURE 1 in terms of their Fourier series when analysed