Higher order address bus - pins and signals , Electrical Engineering

Higher order  Address Bus

The 8085 microprocessor  has 8 pins  dedicated to higher order address A15 - A8. These pins  are used to connect  higher  order address bus. These  pins  generate output signals i e the bus is  unidirectional.

Posted Date: 4/4/2013 3:23:28 AM | Location : United States







Related Discussions:- Higher order address bus - pins and signals , Assignment Help, Ask Question on Higher order address bus - pins and signals , Get Answer, Expert's Help, Higher order address bus - pins and signals Discussions

Write discussion on Higher order address bus - pins and signals
Your posts are moderated
Related Questions
Interpreter- High level language The interpreter is a program  which  translates the high  level  program  into  objects  program  statement wise . it reads one statement of

Give the properties and application of cotton. Cotton : It is base material for insulating fibres. Properties: It can be enhanced by impregnating with varnish. 1)

a) What is meant by Ripple Voltage?  Measure the Ripple Voltage Amplitude, Frequency and DC Offset b) Describe how Ripple Voltage could be decreased.

Explain IMUL instructions in 8086 family with example and their effect on flag. IMUL: It is an instruction for multiplication of two signed numbers. This result is a signed

Q. The line-to-line voltage of a balanced wye connected three-phase source is given as 100 V. Choose V AB as the reference. (a) For the phase sequence A-B-C, sketch the phasor

Refer to the op amp circuit shown below. Let R 1 = 140 k_, R 2 = 10 k_, R 3 = 10 k_, R 4 = 20 k_, RL = 10 k_. Assume the op amp is ideal. Find the equation relating the

Since past few decades, telecommunication systems are continuously evolving from 2G to 3G to 4G etc. This has resulted in multiple technologies and many types of receivers which do

LAN topologies: Network topology is a physical schematic that demonstrates interconnection of the many users. There are four fundamental topologies as under: (i) Direct Connect

Discuss the ENDP assembler directive with example ENDP: It is stands for End Procedure, which informs assembler the end of a procedure. Within assembly language programm

Consider an electromagnet, as shown in Figure, which is used to support a solid piece of steel and is excited by a coil of N = 1000 turns carrying a current i = 1.5 A. The cross-se