Guarding against losses in service cables and connections, Electrical Engineering

Guarding Against Losses in Service Cables and Connections

The service cables to consumer premises are often a source of loss that can be reduced given below. The length of service cables of all consumers taken together can be from 8 to 20 times the length of the LT distribution network.

Posted Date: 2/6/2013 6:10:32 AM | Location : United States







Related Discussions:- Guarding against losses in service cables and connections, Assignment Help, Ask Question on Guarding against losses in service cables and connections, Get Answer, Expert's Help, Guarding against losses in service cables and connections Discussions

Write discussion on Guarding against losses in service cables and connections
Your posts are moderated
Related Questions
Q. A 25-kVA, 2200:220-V, 60-Hz, single-phase transformer has an equivalent series impedance of 3.5 + j4.0  referred to the primary high- voltage side. (a) Determine the highest

Traffic Light Display Design a three color LED system with the following times for each LED: Duration of Green signal : 16s Duration of Yellow signal : 1s Duration of R

#i have an error at in the Matlab power system model..thus i couldn''t run it...

what is direct reading probe

How does the ITU make sure compatibility among the Radio systems used in dissimilar countries?  Why is regulation so significant?

The dielectric constant of air is practically taken as (A) more than unity.                         (B) Unity.  (C) less than unity.                           (D) Zero.

What do you mean by Bezier curve? Shown B0 (1,1), B1 (2,3), B2 (4,3), B3 (3,1) the vertices of Bezier polygon, calculate seven points on Bezier curve. Write in brief the differe

Q. Explain the significance of the Coupling capacitor and the RE - CE circuit. The function of the coupling capacitor is to isolate the amplifier input circuit from the source.

No-load and blocked-rotor tests are conducted on a three-phase,wye-connected inductionmotor with the following results. The line-to-line voltage, line current, and total input powe

assume that the top of the stack in the program is pointed by the register sp.