Gis technology, Electrical Engineering

GIS technology:

GIS could be used to derive diverse information for efficient technical and commercial management of a power distribution utility, e.g., capacity analysis, investment cost estimation, estimation of yearly peak loads of medium and low voltage transformers, calculations of power flow, and technical and commercial losses in the network, and so on.

Proprietary software tools, like SMALLWORLD, PTI, and POWERON, between others, could leverage the GIS database through offering a basket of customised solutions which range from load flow and power loss analyses, network reinforcement, reconfiguration and line design, capacitor and substation placement, relay and fuse co-ordination and etc., to outage and supply complaint management, and job planning and control. The computerized integration of information along with the spatially dispersed links has the ability to greatly enhance the decision making procedure and documentation.

Posted Date: 2/8/2013 6:42:09 AM | Location : United States







Related Discussions:- Gis technology, Assignment Help, Ask Question on Gis technology, Get Answer, Expert's Help, Gis technology Discussions

Write discussion on Gis technology
Your posts are moderated
Related Questions
Q. Internal Frequency Compensation of operational amplifier? Some op amps, such as the 741, have internal RC networks which are intentionally designed to reduce gain at high fr

Q. For the capacitor shown in Figure connected to a voltage source, sketch i(t) and w(t).

In a 3-stage continuous ultrafiltration process, a solution is concentrated from 5 gm/Liter to 50 gm/Liter of protein. The final retentate is to have a flow rate of 1000 L/hr. The

Thevenin's theorem procedure:   1.  Open circuit R L and find Thevenin's voltage (V TH ). 2.  Find Thevenin's resistance (R TH ) when voltage source is short circuit or curren

Q. Explain the construction and operation of Enhancement MOSFET? The construction of an N-channel enhancement MOSFET is shown in figure below. Two highly doped N + regions are

The resistance of a wire is 60 ? at 25 o C and 65? at 75 o C. Find the resistance of wire at 0 o C and value of temperature co-efficient at 0 o C. Ans: Given R 25 = 60 ? a

Give the register organization of 8257? The 8257 do the DMA operation over four independent DMA channels. Each of the four channels of 8257 has a couple of two 16-bit registers

what component will be use for making or logic gates.

A color television receiver is shown in Figure in block diagram form, indicating only the basic functions. The early part forms a straightforward superheterodyne receiver, except f

Q. What is Pinch - off voltage?  The reverse bias is relatively large near the source. As a result, the depletion region intrudes into the channel near the drain, and the effec