geotech, Civil Engineering

Assignment Help:
soil sample investigation

Distomat, definition,old&new modern&difference

definition,old&new modern&difference

Compute the maximum allowable concentrated live load, Given for the section...

Given for the section shown in Figure, M * = 250 kNm, f sy = 500 MPa and f c ′ = 25 MPa. Compute A st and (if necessary) A sc . You may assume that eac

Trigonometry, #question a pilot entering a bay on course 60.3 degrees at sp...

#question a pilot entering a bay on course 60.3 degrees at speed 12 miles per hour sees a light bearing 37.3 true and 20 minutes later he sees it bearing 20.0 degrees true. if he k

Explain about the pre-tensioning systems, Pre-tensioning systems In the...

Pre-tensioning systems In the previous unit we have seen different steps in a pretensioning operation. Tendon wires or strands (formed as a rope type arrangement made of  sever

Theodolite angle measurement, how to measure horizontal angle by theodolite...

how to measure horizontal angle by theodolite

Purpose of dowel bars in elastomeric bearing, Q. Purpose of dowel bars in e...

Q. Purpose of dowel bars in elastomeric bearing? Elastomeric bearing is generallycategorized into two types: free andfixed. For fixed types bridge deck is permitted only to rot

Determine the safe frictional resistance of the pile, A pile is driven in u...

A pile is driven in uniform clay of large depth. The clay has unconfined compression strength of 90 kN/m 2 . The pile is 30 cm diameter and 6 m long. Verify the safe frictional res

Cross section leveling., how to discussion cross section?

how to discussion cross section?

Bearing pressure on soil nail, Question What is relation of bearing pr...

Question What is relation of bearing pressure on soil nail head to ratio La/Lb, where La is length of soil nail before potential slip circle as Lb is length of soil nail beyo

What is the thickness of the concrete seal needed, Design a Cylindrical Ope...

Design a Cylindrical Open Caisson to be sunk by 30 m of sand to support a load of 50 MN. The allowable bearing pressure is 1700 kN/m 2 . Test the feasibility of sinking the caisson