## Describe Geometric information of b-rep, Mechanical Engineering

Assignment Help:

Geometric information of B-rep

Geometric information are usually equations of the edges and faces.

#### Evaluate the speed of shaft, Two shafts A and B are co-axial. A gear C (50 ...

Two shafts A and B are co-axial. A gear C (50 teeth) is rigidly mounted on shaft A. A compound gear D-E gears with C and an internal gear G. D has 20 teeth and gears with C and E h

descripyion

#### What do you mean by centrifugal casting, What do you mean by centrifugal ca...

What do you mean by centrifugal casting ? How are the centrifugal method classified ?

Q. Explain about Corrosion Rates? Corrosion rates of Corrosion data presented in these standards are in graphical form. The corrosion curves for the majority of the metals

#### What are the advantages of gear drive, In general, gear drive is useful for...

In general, gear drive is useful for power transmission among two shafts, which are near to each other (at most at 1m distance). In addition, it has maximum efficiency whereas tran

#### Evaluate thermal efficiency of the engine, A carnot engines performs betwee...

A carnot engines performs between two reservoirs whose difference in temperature is 200 o C. If the work output of the engine is 0.5 times the heat rejected, make evaluation for th

What is a couple

#### Volume fraction of fibres, Volume fraction of fibres: The epoxy materi...

Volume fraction of fibres: The epoxy material is prepared to be stressed to its full strength. What must be volume fraction of fibres? Solution Here σ′ = 1200 MPa,

#### Determine the normal stresses, Determine the normal stresses: A short ...

Determine the normal stresses: A short hollow pier 1.6 m × 1.6 m outsides as well as 1.0 m × 1.0 m intersides supports a vertical load of 2000 kN at a point located on a diago

#### Kinetics of Rectilinear motion, Advantages of work energy principle over D'...

Advantages of work energy principle over D''alambert''s principal.Explain in detail  