Gathering lines, Mechanical Engineering

Gathering Lines:

A gathering line, also called a ladder track, is one into which a number of parallel tracks merge. This is shown in Figure. It is used in marshalling yards.

1988_Gathering Lines.png

Figure: Gathering Lines

Posted Date: 1/23/2013 1:06:47 AM | Location : United States







Related Discussions:- Gathering lines, Assignment Help, Ask Question on Gathering lines, Get Answer, Expert's Help, Gathering lines Discussions

Write discussion on Gathering lines
Your posts are moderated
Related Questions
fully automatic pnuematic cicuit explanation#Minimum 100 words accepted#

How do we calculate BMD for the all type of beams?

(a) For a given material show that the ratio of moment of resistance of a square beam when section is placed with horizontal and vertical sides 41.5%. stronger than the same sectio

Different types of information units of CAD There are different types of information units defined. They are : Class 0 The geometric primitives needed for describing 2- a

Follow board pattern This type of pattern is adopted for those castings where there are some portions which are structurally weak and if not supported properly are likely to br

A load of 2MN is applied on a short concrete column 500 mm x 500 mm. The column is reinforced with four steel bars of 10 mm diameter, one in each corner. Evaluate the stresses in t

how to draw parabola by parallelogram method..?

diameter = 100mm length = 470mm power = 4000 w radians = 78 shear modulus 60000 n/mm^2 determin the maximum shear stress and angle of twist

what do you understand by two like and unlike parallel forces?

Q.  W rite down the basic formula for maximum bending moment in some ideal cases. Sol.:   Ber m together with nature of load Maximu