Force on rigid body - non rigid body, Mechanical Engineering

Force on Rigid body - Non Rigid body:

As Rigid body cannot change its shape on application of any force,

It will begin moving in the direction of applied force without any kind of deformation.

(ii) Non-Rigid body changes its shape on application of any force, "It will begin moving in the direction of applied force with the deformation."

 

 

Posted Date: 10/16/2012 1:19:16 AM | Location : United States







Related Discussions:- Force on rigid body - non rigid body, Assignment Help, Ask Question on Force on rigid body - non rigid body, Get Answer, Expert's Help, Force on rigid body - non rigid body Discussions

Write discussion on Force on rigid body - non rigid body
Your posts are moderated
Related Questions
Q. Corrosion Assessment for Water Disposal System? Due to the high salt contents and oxygen contamination, disposal water is highly corrosive to CS material. HCL line and in

Evaluate resultant of the system: Q: Figure given below shows two vertical forces and couple of moment 2000 Nm acts on horizontal rod, which is fixed at end A .  Determin

EQUIPMENT FOR RESISTANCE WELDING-Measurements Measurement of the parameters are important while fixing the parameters or testing a machine. Resistance welding instrumentation s

Uniformly Varying Load - support reaction: Uniformly Varying Load: In the diagram load varying from Point A to point C. The intensity of it is zero at A and 900N/M at C. Her

Pola r Modulus(Z p ):   It is the ratio of polar moment of the inertia to outer radius. Z p = J / R Polar Modulus of solid body ( Z p ) =[  ?/32. D 4 ]/ D

Draw BCC structure and determine its number of atoms per unit cell, co-ordination number and highest edgeradius relation. Draw FCC structure and determine its number of atoms pe

Determine the component of force: The force of 500N is acting at a point subtends an angle of 60° with the horizontal. Determine the component of force along X and Y dire

The body, suspension and engine mounting system of a vehicle may be idealised as a three degree of freedom system consisting of a bar of mass 1400 kg and the centre of mass at G, 1

In considering a particular fermentation there are a number of choices regarding process operation. Typical  initial considerations are listed below. Again, the choices made will d

The following data is provided for belt transmission dynamometer as shown in figure, NA = 400 r.p.m., DA = 750 mm, DB = DC = DD = 250 mm, L = 800mm, Power = 8KW. Determine :- Th