Flux cored arc welding, Mechanical Engineering

Flux Cored Arc Welding

Single Pass F illet Welds upto (8.0 mm) maximum and groove welds made with a single pass or a single pass each side, may be made using an E70T-X electrode. For electro slag and electro gas welding of exposed, bare, unpainted applications of ASTM A 242 and A 588 steel requiring weld metal with atmospheric corrosion resistance and coloring characteristics similar to that of the base metal. The electrode flux combination shall be in accordance with all weld metal Tension test requirements and the chemical composition shall conform to one of the filler metals.

Posted Date: 9/18/2012 1:53:58 AM | Location : United States







Related Discussions:- Flux cored arc welding, Assignment Help, Ask Question on Flux cored arc welding, Get Answer, Expert's Help, Flux cored arc welding Discussions

Write discussion on Flux cored arc welding
Your posts are moderated
Related Questions
Importance of operation research in decision making

Tensile and Compressive Force: T ensil e Forces A force, that pulls the body, is called as tensile force. Here member AB is tension member carrying tensile force P. As

Calculation of Material Removal Rate MRR = (W i - W f ) × 1000/ 7.8 × T .......................................... (1) W i = Initial weight of work piece W f = Final w

Evaluate the maximum bending stresses: A beam of I-section illustrated in Figure is simply supported over a span of 10 m. It carries an uniform load of 4 kN/m over the whole s

Lap or fillet joint Lap joint is obtained by overlapping the plates and welding their edges. The fillet joints may  be single transverse fillet, double transverse fillet or par

what is internal combustion engine

Distinguish between microscopic and macroscopic approaches. Describe thermodynamic system. Differentiate between closed system, open system and an isolated system.

Determine the maximum shear stress and angle of twist: A hollow circular shaft of 6 m length and inner & outer diameter ois equal to 80 mm and 100 mm is subjected to a torq

Austempering: The component to be hardened is initialy austenised and after that quenched into a lead or salt bath held at just over the martensite transformation temperature

Derive 3-D non-steady state conduction equation in spherical co-ordinates. Explain the assumption involved. The hot combustion gases of a furnance are divided from the ambient a