## flow rate, Mechanical Engineering

Assignment Help:
how to calculate flow rate of liquid nitrogen?
melting point(-210deg)
boiling point(-195.8deg)
critical temp(-149.9deg)
relative density(0.8)
specific gravity(808.5kg/m^3)
relative gas density(0.97)
molecular mass(28g/mol)

#### Explain general phase of radial drilling machine, General Phase of Radial D...

General Phase of Radial Drilling Machine Steps- 1. Prepare a strong foundation for the value study. In radial drilling machine hole can not be produce in any angle.

#### Heat treatment of cast iron, Heat Treatment of Cast Iron: Castings in...

Heat Treatment of Cast Iron: Castings in iron are frequently heat treated for enhancing mechanical properties and microstructure. The treatments known to cast iron are explai

#### Thermodynamics, we can use in proove of energy is a propertyof system we ca...

we can use in proove of energy is a propertyof system we can use (E) instead of (dQ-dW)

#### How can you implement permeability test, Q. How can you implement Permeabil...

Q. How can you implement Permeability test  As already defined, permeability of porosity of the moulding sand is the message of its ability to permit air to flow through it.

#### Motion on the inclined plane when the surface is rough, Motion on the incli...

Motion on the inclined plane when the surface is rough:   The figure given above shows a body having weight W, sliding down on rough inclined plane. Assume, θ= Angl

#### Materials, ">http://www.expertsmind.com/questions/the-percentage-elongation...

">http://www.expertsmind.com/questions/the-percentage-elongation-of-the-metal-stress-30138407.aspx

#### Design temporary storage, Q. Design Temporary Storage? It is sometimes ...

Q. Design Temporary Storage? It is sometimes acceptable to store drums temporarily on spill containment pallets. Each pallet should be capable of capturing the contents of at l

#### Compressive stress, Compressive Stress: The stress induced in a body, ...

Compressive Stress: The stress induced in a body, when subjected to two equal and opposite pushes as shown in figure (a) as a result of which there is an decrease in length

#### Describe dry and wet parting materials, Q. Describe Dry and wet parting mat...

Q. Describe Dry and wet parting materials? Dry parting materials: These are applied by dusting. These include : charcoal, ground bone and limestone, lycopodium(a yellow veget

#### Kinematics and Dynamics of Machinery, I have Four (4) questions related to ...

I have Four (4) questions related to Kinematics and Dynamics of Machinery . I need them exactly after 30 hours. Thanks and please do let me know.