Fire precautions - fire protection engineering, Other Engineering

Fire precautions - fire protection engineering:

Fire precautions include:

  • Protecting escape routes in fire resisting construction,
  • Providing fire doors between escape routes and risk areas,
  • Providing a fire alarm system so that people are warned of fire,
  • Providing emergency lighting,
  • Providing escape signs,
  • Training staff in fire procedures.

In the fire prevention process the hazards are things that may cause a fire to start. In  the  fire  precautions  process  the  hazards  are  fire  and  the  smoke  and  heat  it produces.

Posted Date: 10/22/2012 5:54:01 AM | Location : United States







Related Discussions:- Fire precautions - fire protection engineering, Assignment Help, Ask Question on Fire precautions - fire protection engineering, Get Answer, Expert's Help, Fire precautions - fire protection engineering Discussions

Write discussion on Fire precautions - fire protection engineering
Your posts are moderated
Related Questions
Turbo shaft engines : Gas turbine engines that deliver power through a shaft to operate something other than a propeller are referred to as turboshaft engines. In most cases th

Pitch control unit (pcu) operation: The action of the Governor bob weights, due to the varying RPM of the engine, is to raise or lower an internal piston to cover or open fluid

connecting probe in CRO causes


PRESSURE RELIEF VALVE The pressure relief valve shown in the figure. controls the oil pressure at the pre-set value demanded by the system. The valve is normally integral with

Double acting feathering system: To prevent excessive drag in the event of a propeller on engine failure, the double acting propeller as with the single acting propeller requir

Fins vs Canards  Canard control - Good lift/latax control for moderate angles of attack. - Shed vortices can interfere with tail to generate roll moment. - Tendency to stall

Guidance Control system The control aspect of the guidance system is intended to stabilise the behaviour of the airframe.  The fact that the guidance system will always h

Direct from engine compressor: A Load valve is switched on from the flightdeck, power for the switch is available once the APU has achieved 95% + 3 sec. This energises the swit

What are the problems arises during construction and their solutions