finite element analysis (bridge), Civil Engineering

I am a final year civil and structural student and i need your help about my final year project.

My Final Year Topic:
Finite Element Analysis of a bridge using Sap2000

Aim:
Finite element analysis using Sap 2000.

Objectives:
1- Model the bridge.
2- Subject to certain loading. (dead and live;wind and earthquake, vehicles and pedestrians)
3- Finalize the results.

Provisional Table of Contents
Acknowledgements.
Abstract.
Introduction.
Literature Review.
Cable-stayed bridge.
How to Build a Bridge Model in Sap2000 V14.2
Building the Bridge Model in Sap2000 v14.2
Analysis of the Bridge Model.
Conclusion.
References.

I would like to build The Clark Bridge which is a cable-stayed bridge across the Mississippi River between West Alton, Missouri and Alton, Illinois.
Posted Date: 2/5/2013 6:04:09 PM | Location : United Kingdom







Related Discussions:- finite element analysis (bridge), Assignment Help, Ask Question on finite element analysis (bridge), Get Answer, Expert's Help, finite element analysis (bridge) Discussions

Write discussion on finite element analysis (bridge)
Your posts are moderated
Related Questions
differences between highway pavement and airfield pavement

derivation for traverse shear stress in beams

Q. Pumping at joints in concrete carriageway? Pumping at joints in concrete carriageway takes place in the presence of the below factors: (i)  Fine-grained subgrade (ii)

Calculate the concrete tensile strength A 6 in. by 12 in. concrete cylinder resisted a transverse force of 55,000-lbf, at 28 days, in a split tensile cylinder test. Calculate t

Q. Earth work in high embankments? (a) Borrow pits must not be dug close to telegraph poles, electric poles, level crossings, bridges a culverts, or within 800 meters of the bo

Binders : Cement: Cement as a Binder Cement is one of the main ingredients of concrete. When cement sets (with the addition of water), it forms a paste and binds the

A trapezoidal masonry retaining wall 1 m wide at top and 3 m wide at its bottom is 4 m high. The vertical face is retaining soil (φ = 30°) at a surcharge angle of 20° with the hori

battened system with end tie plate

determine the force p if the block is move yto the right at an angle of friction on all contact points @20 degrees

Question Designing of access ramps for drainage channels, why must direction of access ramps is sloping down on the way to downstream ? Answer In designing of access