Find resistance of the armature circuit and field circuit, Electrical Engineering

When delivering rated load a 10-kW, 230-V self excited shunt generator has an armature-circuit voltage drop that is 6% of the terminal voltage and a shunt-field current equal to 4% of the rated load current. Calculate the resistance of the armature circuit and the field circuit.

Posted Date: 6/14/2013 8:00:49 AM | Location : United States







Related Discussions:- Find resistance of the armature circuit and field circuit, Assignment Help, Ask Question on Find resistance of the armature circuit and field circuit, Get Answer, Expert's Help, Find resistance of the armature circuit and field circuit Discussions

Write discussion on Find resistance of the armature circuit and field circuit
Your posts are moderated
Related Questions
Consider the following signals, sketch each one of them and comment on the periodic nature: (a) x(t) = A cos(2πf 0 t + θ), where A, f 0 , and θ are the amplitude, frequency, and

The aim of the research paper is to design a crossover circuit for loudspeaker that will be used with a 2-way speaker. Circuit consists of the resistors, capacitors and operational


i have an assignment related to magnetic field i have attached the( MRI assignment sheet)[1] please read it carefully in the assignment 2 methods to get the results - one by

Terminal The  oval symbol  show below in  indicate terminal of the  program.  Usually  words  like START BEGIN  STOP END  are written  in terminal symbol.           START

Q. A magnetic circuit is found to have an ac hysteresis loss of 10 W when the peak current is Im = 2 A. Assuming the exponent of Bm to be 1.5, estimate Ph for Im = 0.5A and 8A.

Parallel Operation of Interconnected Synchronous Generators In order to assure continuity of the power supplywithin prescribed limits of frequency and voltage at all the load p

Explain Noise Noise is unwanted signals which degrade the desired signal content and therefore the performance of the system. Noise might be produced either externally or inte

short note on priming

For the amplifier circuit shown below estimate the mid band voltage gain if the EARLY voltage (V A ) of the current mirror transistors is 80 volts.  Assume the d.c biasing is optim