Features of a stratigraphical survey phase, Civil Engineering

Features of a Stratigraphical Survey phase

The principal features of a Stratigraphical Survey phase are:

a)  Determination of depth of ground water, thickness, extent and approximate identity of strata to the required depth below the ground level,

b)  Collection of soil, rock and ground water samples for positive identification of material in the strata, and

c)  To make observations and certain minor field tests which will assist in the  determination  of condition  of samples and estimation of physical properties  of  the material.

 

Posted Date: 9/3/2013 5:23:51 AM | Location : United States







Related Discussions:- Features of a stratigraphical survey phase, Assignment Help, Ask Question on Features of a stratigraphical survey phase, Get Answer, Expert's Help, Features of a stratigraphical survey phase Discussions

Write discussion on Features of a stratigraphical survey phase
Your posts are moderated
Related Questions
Analyse the state of stress at the critical section: A prismatic bar of circular section with 80 mm diameter is subjected to bending moment of 5 kN-m and a torque of 7 kN-m. A

Nonsymmetrical loading of the snow A decrease in snow weight in some parts of a roof because of the wind, or melting from the heath, or the sun light would reduce internal powe


what is the yield stress for reinforcement steel?

Define Equipments required for conducting UWMT? Equipments required for conducting UWMT are: Inspection Equipment: a) Electronic yoke with power cable b) Ground fault interr

Q. What is Immediate Settlement? Strain in all coarse grained, dry or partly saturated fine grained soils occur immediately after the application of stress. Hence, this change

The transmission main from the well field to the community is 2500 ft, the velocity of flow at peak pumping capacity is 3.5 fps, water temperature is 10oC, and pH is 7.5. If free c

The discharge of water collected from a constant head permeameter in a period of 15 minutes is 500 ml. The internal diameter of the permeameter is 5 cm and the measured difference


how to find total hardness by EDTA