Evaluting Properties, Mechanical Engineering

A piston-cylinder assembly fitted with a paddle wheel contains air, initially at p1=30 lbf/in2, T1=540 °F, and V1=4 ft3. The air undergoes a process to a final state where p2=20 lbf/in2, V2=4.5 ft3. During the process, the paddle wheel transfers energy to the air by work in the amount 1 Btu, while the air transfers energy by work to by the piston in the amount 3.31 Btu. Assuming ideal gas behavior, determine for the air (a) the temperature at state 2, in °R.
Posted Date: 9/30/2012 11:52:26 PM | Location : United States







Related Discussions:- Evaluting Properties, Assignment Help, Ask Question on Evaluting Properties, Get Answer, Expert's Help, Evaluting Properties Discussions

Write discussion on Evaluting Properties
Your posts are moderated
Related Questions
Corollaries of first law of thermodynamics: First law of thermodynamics has significant corollaries. Cor ollary 1: (First Law for process). There exists property of

Limit of proportionality: Limit of proportionality is the stress at which the stress - strain diagram ceases to be a straight line that is, stress at which the extension ceas

Q. Explain the protocol for stress testing? The protocol for stress testing should be structured to include the following: 1) Continuous ECG monitoring. 2) Hard copy ECG

Q. What is Boiler feedwater? The boiler feedwater will be a mixture of desalinated water, treated make-up water and returned condensate, deaerated and heated, supplied by other

Q. Setting and installations of insulation? The setting and installations of insulation shall be to Specification No. later. The steam drum surfaces shall be insulated with

What is the difference between blowholes & porosity in casting ?

(a) Explain various types of methods of refrigeration. (b) Write the factors consideration for the selection of refrigerant for a system. A 5 tonne refrigerating machine oper

derive the torsion formula as (torsion divided by radius) is equal to (modulus of rigidity multiplied by twist of angle all divided by the length of a cylinder)

Clutch free play: Check for free play of the clutch lever, it should be within 10-20 mm.

The Specifications for use on a project will be as defined in the ‘Project Execution Plan'. The specification requirements will be clarified in the Engineering Estimate or at the