Estimate the the volume of water in the tank, Electrical Engineering

A conical tank is shown in Figure. The tank is filled with water.  Using MATLAB, determine:

a.   the volume of water in the tank

b.   the weight of the water in the tank.

1050_diameter.png

Posted Date: 4/2/2013 4:01:40 AM | Location : United States







Related Discussions:- Estimate the the volume of water in the tank, Assignment Help, Ask Question on Estimate the the volume of water in the tank, Get Answer, Expert's Help, Estimate the the volume of water in the tank Discussions

Write discussion on Estimate the the volume of water in the tank
Your posts are moderated
Related Questions
Q. Given that a silicon n-channel JFET has V P = 5 V and I DSS = 12 mA, check whether the device is operating in the ohmic or active region when v GS =-3.2 V and i D = 0.5 mA.

Question: Consider the circuit shown in Figure. There is no initial energy stored in the circuit until time t=0 when the switch is closed. (i) Transform the given circ

Altavox is a manufacturer and distributor of a lot of electronic instruments and devices, including digital/analog multimeters, function generators, oscilloscopes, frequency counte

Q. What is the advantage of a two-stage overloaded RC coupled amplifier over a single stage one? What are it's uses? It is a frequently encountered configuration. Here, the tra

Look at figure below and use.  Water (50°F) flows at 250 gpm through the pipe system at the bottom of this page. All piping is four inch (4") diameter cast iron. The distance betwe

Consider an electromagnet, as shown in Figure, which is used to support a solid piece of steel and is excited by a coil of N = 1000 turns carrying a current i = 1.5 A. The cross-se

I have a project due tomorrow, i have exhuasted all my resources, and cannot understand how to do the project, it is VHDL coding in Quartus program, i can send the assignment if yo

Bureau of Energy Efficiency Setting up of the Bureau of Energy Efficiency The Bureau of Energy Efficiency has been established with effect from 1st March, 2002 under the

One byte Instructions One byte  instruction include  both the opcode  operand in the  same byte. To identify  one byte  instruction one  must  observe followings  things .

expain how to do proper initial approximatio for the given cct....... by a example