Entropy, Mechanical Engineering

why entropy always tends to increase?
Posted Date: 10/14/2012 11:53:51 AM | Location : United States







Related Discussions:- Entropy, Assignment Help, Ask Question on Entropy, Get Answer, Expert's Help, Entropy Discussions

Write discussion on Entropy
Your posts are moderated
Related Questions
comparing the different coding systems ?

A steel dia 10 mm passes through a brass tube of internal dia 15mm and external dia is 25 mm. The bolt is tightened by a nut. The length of tube is reduced by 1.5mm and the length

Q. 11: What is relation between the maximum tensile stress and the maximum compressive stress in any section of beam? Sol.: L et us assume inverted angle section of the beam a

Determine about the extent of excavation The extent of excavation depends upon the construction problems like dewatering and uplift. In extreme cases anchoring of the box may b

determine the shear force and bending moments of 4KN fprce

Figure shows a Warren girder consisting of seven members each of 3 m length freely supported at its end points. The girder is loaded at B and C as given. Determine the forces in al

One of the simplest devices that have both vertical and horizontal motion is a slide or chute. It may be straight or spiral and is static in nature. Gravity is utilized in

Evaluate the point of contraflexure: An overhanging beam of 15 m span is carrying a consistently distributed load of 1 kN/m over the length of 10 m at a distance 5 m from the

Argon Argon is approximately one and one third times as heavy as air and ten times heavier than helium. Argon, after leaving the torch nozzle, forms a blanket over the weld

A cantilevered beam is to be made of 7075-T6 aluminum with a uniaxial yield strength of 469 MPa. The beam is 1m long, and is loaded with the following limit loads: a bending mome